› view more photos

The Enco Systems 4-in-1 update kit for CD jukeboxes will update the electronics of the CD player system of a jukebox loaded with a CDM-4/53 Industrial player into electronics to work with a state-of-the-art CD-Pro player. This kit is not designed to work with CDM-3 or CDM-4/36 Heavy Duty.

Philips CDM-4 Industrial players were installed as original equipment by many jukebox manufacturers. This kit was designed to convert machines made by any of the four major global manufacturers: Rowe, Wurlitzer, NSM, Rock-Ola.

INSTALLATION INSTRUCTIONS

To install this update system, locate the Philips monoboard inside the jukebox and replace it with the 4-in-1 update board. (For example, in a Rowe jukebox the Philips monoboard is found inside the Mechanism Control housing mounted to the right of the changer mechanism. In an NSM jukebox it’s mounted underneath the top of the changer assembly.)

Unplug all wire harnesses that are connected to the CDM-4/53 Industrial. Unplug the 15-pin black flat cable ONLY from the Philips monoboard side (leave the other end connected). Remove the Philips monoboard and then use the same fasteners to secure the 4-in-1 update board in its place.

Connect the 15-pin flat cable in its original orientation (see note above) into the 15-pin connector on the 4-in-1 update board, as noted above.

IMPORTANT NOTE: The 15-pin connector on the 4-in-1 update board works in the opposite way as the connector on the Philips monoboard. The 4-in-1 update board connector is a Molex spring connector – both ends must be held down while inserting the leads. The leads are locked in place when the spring is released.

Connect the provided new wire harness to the 12-pin connector on the 4-in-1 update board.